Cisco Systems H.323 Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Brány / ovladače Cisco Systems H.323. Cisco Systems H.323 User's Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 32
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
CHAPTER
3-1
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
3
Provisioning the Cisco HSI
Introduction
This chapter describes the data that must be provisioned for the Cisco H.323 Signaling Interface (HSI).
The data is divided into two areas: system configuration and H.323 stack data. This chapter contains the
following sections:
Cisco HSI Configuration, page 3-1
H.323 Stack Configuration, page 3-10
HSI Feature Configuration, page 3-22
Cisco HSI Configuration
All configuration data is contained within configuration files. Cisco HSI starts with an initial
configuration file in $GWHOME/currentGW/etc/GWmain.conf. This file is created during installation
of the software.
The configuration data within the file is defined as dynamic, static, or constant:
Dynamic data can be modified by a provisioning session (see Appendix A, “MML User Interface
and Command Reference”). It can be activated on the currently running Cisco HSI.
Static data can be modified by a provisioning session but cannot be activated on a running
Cisco HSI. Changes to dynamic and static data can be written to a separate provisioning file (in
$GWHOME/currentGW/var/prov/configname/session.dat) that can be used during subsequent
restarts of the Cisco HSI.
Constant configuration data is contained within the configuration file and cannot be modified by
provisioning sessions. Constant configuration data can be modified only by system technicians or
administrators who use UNIX editing tools. This data is replicated from the initial configuration file
into the provisioning files, and is included in subsequent provisioning sessions.
Examples of the use of constant data are given in Appendixes D, E, F, and G. These appendixes
determine the mapping of cause values for incoming and outgoing H.323 and Enhanced ISDN User
Part (E-ISUP) messages. System technicians can modify these values in the initial configuration file
to explicitly choose the mappings for their system.
When a provisioning session creates a new configuration file, it also verifies that provisioned data is
within allowable ranges and indicates this in the start of the file. It checksums the configuration file and
writes the checksum as $GWHOME/currentGW/var/prov/configname/checksum.dat. When the Cisco
Zobrazit stránku 0
1 2 3 4 5 6 ... 31 32

Shrnutí obsahu

Strany 1 - Provisioning the Cisco HSI

CHAPTER3-1Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A143Provisioning the Cisco HSIIntroductionThis chapter describes the data that mus

Strany 2 - MML Configuration Commands

3-10Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationH.323 Stack Configu

Strany 3 - Verifying the Configuration

3-11Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationNonprovisionable Da

Strany 4 - System Configuration Data

3-12Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationExampleprov-add:nam

Strany 5 - Cisco HSI Configuration

3-13Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationRAS ParametersThe p

Strany 6

3-14Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationallowCallsWhenNonRe

Strany 7 - Changing Static System Data

3-15Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationH.245 ParametersTo

Strany 8 - Dynamic System Data

3-16Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationTable 3-10, Table 3

Strany 9

3-17Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack Configurationcaps.table[i].audio

Strany 10 - H.323 Stack Configuration

3-18Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationCodec SelectionThe

Strany 11 - MML Provisionable Data

3-19Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationThe following MML c

Strany 12 - OL-4806-01 Rev. A14

3-2Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSICisco HSI ConfigurationHSI starts up, it atte

Strany 13 - RAS Parameters

3-20Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationTable 3-14 Common S

Strany 14

3-21Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIH.323 Stack ConfigurationThe following MML c

Strany 15 - H.245 Parameters

3-22Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationTable 3-16 presents

Strany 16 - Table 3-9 H.245 Parameters

3-23Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature Configuration• Configuring G.726

Strany 17 - Table 3-12 H.245 Modes

3-24Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationRefer to Cisco PGW

Strany 18 - Codec Selection

3-25Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationSupport for the H.2

Strany 19

3-26Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationTable 3-17 presents

Strany 20

3-27Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationConfiguring G.726 o

Strany 21

3-28Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationIf a non-preferred

Strany 22 - HSI Feature Configuration

3-29Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationH245, caps.table[i]

Strany 23 - H.323 Hairpin

3-3Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSICisco HSI ConfigurationIntroduction to MML Co

Strany 24 - T.38 Fax

3-30Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationH245, caps.table[i]

Strany 25 - HSI Support for Tech Prefixes

3-31Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationConfiguring G.729 A

Strany 26 - Note This parameter

3-32Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSIHSI Feature ConfigurationH245,modes[i].name

Strany 27

3-4Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSICisco HSI ConfigurationStep 2 To display the

Strany 28 - Note These string values

3-5Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSICisco HSI ConfigurationTable 3-3 Static Syste

Strany 29 - Note Set this parameter to

3-6Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSICisco HSI ConfigurationPavoRedirPresInd [0-3

Strany 30 - Note This field is an

3-7Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSICisco HSI ConfigurationChanging Static System

Strany 31

3-8Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSICisco HSI ConfigurationDynamic System DataTo

Strany 32

3-9Cisco H.323 Signaling Interface User GuideOL-4806-01 Rev. A14Chapter 3 Provisioning the Cisco HSICisco HSI ConfigurationOVLDLEVEL1PERCENT Indi

Komentáře k této Příručce

Žádné komentáře