Cisco Systems WSC2960XR48FPSI Uživatelský manuál stáhnout pdf (Strana 126)

If you are configuring a port on a cluster member switch as a dynamic-access port, first use the rcommand

privileged EXEC command to log in to the cluster member switch.

Before You Begin

You must have IP connectivity to the VMPS for dynamic-access ports to work. You can test for IP connectivity

by pinging the IP address of the VMPS and verifying that you get a response.

To return an interface to its default configuration, use the default interface interface-id interface

configuration command. To return an interface to its default switchport mode (dynamic auto), use the no

switchport mode interface configuration command. To reset the access mode to the default VLAN for

the switch, use the no switchport access vlan interface configuration command.

Note

SUMMARY STEPS

configure terminal

interface interface-id

switchport mode access

switchport access vlan dynamic

end

show interfaces interface-id switchport

copy running-config startup-config

DETAILED STEPS

PurposeCommand or Action

Enters the global configuration mode.configure terminal

Example:

Switch# configure terminal

Step 1

Specifies the switch port that is connected to the end

station, and enters interface configuration mode.

interface interface-id

Example:

Switch(config)# interface gigabitethernet 1/0/1

Step 2

Sets the port to access mode.switchport mode access

Example:

Switch(config-if)# switchport mode access

Step 3

Catalyst 2960-XR Switch VLAN Configuration Guide, Cisco IOS Release 15.0(2)EX1

112 OL-29440-01

Configuring VMPS

Configuring Dynamic-Access Ports on VMPS Clients

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 177 178

Žádné komentáře

Cisco Systems WSC2960XR48FPSI Uživatelský manuál Strana 126