Cisco Systems IOS XR Uživatelský manuál Strana 95

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 282
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 94
Implementing BGP on Cisco IOS XR Software
Where to Go Next
RC-79
Cisco IOS XR Routing Configuration Guide
neighbor 199.99.99.2
remote-as 700
In a BGP speaker in autonomous system 6003, the peers from autonomous systems 6001 and 6002 are
configured as special eBGP peers. Peer 200.200.200.200 is a normal eBGP peer from autonomous
system 701.
router /jointfilesconvert/86220/bgp 6003
/jointfilesconvert/86220/bgp confederation identifier 666
/jointfilesconvert/86220/bgp confederation peers 6001 6002
neighbor 171.69.232.57
remote-as 6001
neighbor 171.69.232.55
remote-as 6002
neighbor 200.200.200.200
remote-as 701
The following is a part of the configuration from the BGP speaker 200.200.200.205 from autonomous
system 701 in the same example. Neighbor 171.69.232.56 is configured as a normal eBGP speaker from
autonomous system 666. The internal division of the autonomous system into multiple autonomous
systems is not known to the peers external to the confederation.
router /jointfilesconvert/86220/bgp 701
neighbor 171.69.232.56
remote-as 666
neighbor 200.200.200.205
remote-as 701
BGP Route Reflector: Example
The following example shows how to use an address family to configure internal BGP peer 10.1.1.1 as
a route reflector client for both unicast and multicast prefixes:
router /jointfilesconvert/86220/bgp 140
neighbor 10.1.1.1
remote-as 140
address-family ipv4 unicast
route-reflector-client
router /jointfilesconvert/86220/bgp 140
neighbor 10.1.1.1
remote-as 140
address-family ipv4 multicast
route-reflector-client
Where to Go Next
For detailed information about BGP commands, see the Cisco IOS XR Routing Command Reference
document.
Zobrazit stránku 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 281 282

Komentáře k této Příručce

Žádné komentáře