Cisco Systems Network Cabling Uživatelský manuál stáhnout pdf (Strana 11)

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE 26

7. Set the host name of the switch stack, as follows:

8. Set the switch stack’s enable password, as follows:

9. Turn off the VLAN trunking protocol (VTP), as follows:

sw01(config)#

Setting device to VTP TRANSPARENT mode.

10. Enable the

portfast bpduguard

feature, as follows:

At this prompt... Enter... Notes

Switch(config)# hostname sw01

Use your site-specific name instead

of sw01 used as an example; each

switch should have a unique name.

At this prompt... Enter... Notes

sw01(config)# enable secret system

Use your site-specific password

instead of the system password used

as an example.

At this prompt... Enter... Notes

sw01(config)# vtp mode transparent

Displays the following output:

At this prompt... Enter... Notes

sw01(config)# spanning-tree portfast bpduguard default

Enabling this feature protects

against cabling errors. If a spanning

tree packet does arrive on a port

that has this feature enabled, the

port is disabled.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Žádné komentáře

Cisco Systems Network Cabling Uživatelský manuál Strana 11