Cisco Systems 10200 Uživatelský manuál stáhnout pdf (Strana 89)

5-13

Cisco BTS 10200 Softswitch Operations and Maintenance Guide, Release 6.0.x

OL-16000-07

Chapter 5 Managing External Resources

Managing Subscriber Terminations

If a subscriber termination command fails, it can return one of the following generic failure reasons, as

well as ones specific to the command.

Changing subscriber

termination states

control subscriber-termination id=*@c3810_167; mode=forced; tar-

get-state=INS;

Possible states:

• INS—In-service

• OOS—Out of service

• MNT—Maintenance mode

control subscriber-termination id=sub2-ctx2; mode=forced;

target-state=maint;

Forces MAINT state, do this before testing

equip subscriber-termination [email protected];

Changes OOS subscriber terminations to UEQP

unequip subscriber-termination [email protected];

Changes INS subscriber terminations and puts them in UEQP, subscriber

terminations state must be UEQP before you can delete them.

Viewing test menus

diag subscriber-termination; test=<TAB>

diag subscriber-termination; test=<RETURN>

Testing subscriber

terminations

(place subscriber

terminations in

MAINT state first)

diag subscriber-termination [email protected]; test=3;

ring-duration=10;

Note Ring-duration values are 0–999 (Default = 5). Maximum ring time is

30 seconds regardless of whether the duration is set higher than or

equal to 31.

1. Tests if MGCP has access to the termination

2. Tests if there is a path to the device (ping)

3. Tests if the subscriber can be rung

4. Performs tests 1 through 3

Table 5-5 Managing Subscriber Terminations (continued)

Task Sample Command

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 213 214

Žádné komentáře

Cisco Systems 10200 Uživatelský manuál Strana 89