
Verifies the operational state of the auto-MDIX
feature on the interface.
show controllers ethernet-controllerinterface-id
phy
Example for Configuring Auto-MDIX
This example shows how to enable auto-MDIX on a port:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# speed auto
Switch(config-if)# duplex auto
Switch(config-if)# mdix auto
Switch(config-if)# end
Catalyst 2960-X Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX
44 OL-29034-01
Configuring Auto-MDIX
Example for Configuring Auto-MDIX
Komentáře k této Příručce