Cisco Systems WSC2960X48TDL Uživatelský manuál stáhnout pdf (Strana 59)

•

TFTP

•

Secure Shell (SSH)

•

DHCP-based autoconfiguration

•

SMNP (only the ENTITY-MIB and the IF-MIB)

•

IP ping

•

Interface features

◦ Speed—10 Mb/s, 100 Mb/s, and autonegotiation

◦ Duplex mode—Full, half, and autonegotiation

◦

Loopback detection

•

Cisco Discovery Protocol (CDP)

•

DHCP relay agent

•

IPv4 and IPv6 access control lists (ACLs)

Before enabling a feature on the Ethernet management port, make sure that the feature is supported. If

you try to configure an unsupported feature on the Ethernet Management port, the feature might not work

properly, and the switch might fail.

Caution

How to Configure the Ethernet Management Port

Disabling and Enabling the Ethernet Management Port

To disable or enable the Ethernet management port in the CLI, follow this procedure.

SUMMARY STEPS

configure terminal

interface fastethernet0

shutdown

no shutdown

exit

show interfaces fastethernet0

Catalyst 2960-X Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX

OL-29034-01 47

Configuring Ethernet Management Port

How to Configure the Ethernet Management Port

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 107 108

Žádné komentáře

Cisco Systems WSC2960X48TDL Uživatelský manuál Strana 59